|
Post by shuttlespanker on Jan 14, 2023 10:00:38 GMT
Good morning all, a couple of quick questions regarding the fitting of indicators My 250 superdream didn't have any indicators fitted on it when I bought it, so, I have seen various places and prices of where I can get them from Now, my question is, I have seen that there are actual fittings for them, as seen in the pic below I understand that the black plastic part will fit either side, but, is it top side on one side and bottom side on the other? Or both on top, but facing opposite directions And, how do the front indicators fit? I have not seen the fittings for them Also, does anyone know the actual size and type of screw that secures the right bar switch gear in place? Any help will be greatly appreciated
|
|
|
Post by BritPete on Jan 14, 2023 10:44:01 GMT
Good morning all, a couple of quick questions regarding the fitting of indicators My 250 superdream didn't have any indicators fitted on it when I bought it, so, I have seen various places and prices of where I can get them from Now, my question is, I have seen that there are actual fittings for them, as seen in the pic below I understand that the black plastic part will fit either side, but, is it top side on one side and bottom side on the other? YESOr both on top, but facing opposite directions And, how do the front indicators fit? An M6 Flange Bolt goes through the indicator hole and screws into the Headlamp mounting ears on the dedicated brackets - There is a small spacer as seen above, diameter sized to fit through the indicator holeI have not seen the fittings for them Also, does anyone know the actual size and type of screw that secures the right bar switch gear in place? One is M5X35mm and one M5x25mm Both Pan Head - I have used Hex Heads and a washer on mine much easier to manageAny help will be greatly appreciated See above
|
|
|
Post by shuttlespanker on Feb 11, 2023 13:03:57 GMT
Another question......
I have located the wiring for the rear indicators, but, I cannot find any trace of the wiring for the front
Can anyone show me where the indicator wiring comes out from the loom, and the actual routing of it
Thanks
|
|
|
Post by duffer on Feb 11, 2023 13:25:25 GMT
Inside the headlight you will find orange and light blue wires with female connections. The front indicator wires should have a suitable blue or orange collar at the male fitting end, and be long enough to reach into the headlight. Simple as that.
|
|
|
Post by shuttlespanker on Feb 11, 2023 13:26:33 GMT
Inside the headlight you will find orange and light blue wires with female connections. The front indicator wires should have a suitable blue or orange collar at the male fitting end, and be long enough to reach into the headlight. Simple as that. Thank you, time for a nosey in the headlight unit
|
|